Installation
Procedures
Apollo CNX80 Installation Manual
560-0982-00 Rev D
2-27
2.8.7 A
NNUNCIATOR
O
UTPUTS
NOTE
Installations in conformance with the requirements specified in this installation manual
may not require the use of any external annunciators, since all annunciations are provided
on the CNX80 front panel. Refer to 2.5.3 to determine whether or not external
annunciators are required.
All of the annunciator outputs duplicate annunciations available on the front of the CNX80. These can be
used to drive annunciator lamps to make the annunciation available remotely (such as in the pilot’s primary
field of view). All of these outputs are active low (i.e. grounded when active, and open otherwise). Each is
an open collector output capable of sinking up to 400 mA. These outputs are normally open and are only
grounded under the conditions described herein.
2.8.7.1 GPS / Nav Annunciations
P7-17 GPS Indicator Out
P7-18 NAV Indicator Out
The GPS Indicator Out (P7-17) will be grounded when GPS is being used as the navigation source to drive
the Main CDI, and open otherwise. The NAV Indicator Out (P7-18) will be grounded when VOR/ILS is
being used as the navigation source to drive the Main CDI, and open otherwise.
If external annunciators are used for the GPS/Nav annunciation, it is recommended that the GPS
annunciator is labeled “GPS” in white text, and the Nav annunciator is labeled “NAV” in green text.
Alternately, the annunciator may be labeled with “GPS” in black text on a white background, and “NAV”
in black text on a green background.
2.8.7.2 Back Course Annunciation
P7-15 Back Course Out
The Back Course Out will be grounded when the back course localizer mode is enabled.
If an external annunciator is used for back course annunciation, it is recommended that the back course
annunciator be labeled “BC” in amber text.
2.8.7.3 Dead Reckoning Annunciation
P5-60 Dead Reck Annc
The Dead Reck Annc output is grounded whenever the CNX80 is in dead reckoning mode (i.e. whenever
the GPS position is lost and the last-known groundspeed is > 3kts).
If an external annunciator is used for dead reckoning annunciation, it is recommended that the dead
reckoning annunciator be labeled “DR” in amber text.
Summary of Contents for Apollo CNX80
