Configuration settings in the OSD
25
· G&D DP1.2-MUX3-ATC
Network settings
The device provides two network interfaces (
Network A
and
Network B
). The network
interfaces allow you to integrate a device into up to two separate networks.
Configuring the network interfaces
To connect the device to a local network, you need to configure the network set-
tings.
How to configure the settings of a network interface:
1. Press
Ctrl+Num
(default) to open the on-screen display.
2. Press
F11
to open the configuration settings.
3. Use the
arrow keys
to select
Network
and press
Enter
.
4. Use the
arrow keys
to select
Interfaces
and press
Enter
.
5. Enter the following values under
Interface A
or
Interface B
:
6. Press
F2
to save your settings.
NOTE:
By default, the following settings are preselected:
IP address of
Network interface A
:
192.168.0.1
IP address of
Network interface B
:
Obtain settings via
DHCP
Global network settings
Obtain settings via
DHCP
IMPORTANT:
The operation of both network interfaces within one subnet is not
permitted.
NOTE:
The
Link Local
address space 169.254.0.0/16 iis reserved for internal com-
munication between devices according to RFC 3330. It is not possible to assign an
IP address of this address space!
Operational
mode:
Select the operational mode of
Interface A
or
Interface B
:
Off:
Switch off network interface.
Static:
A static IP address is assigned.
DHCP:
Obtain IP address from a DHCP server.
IP address:
Enter the IP address of the interface - only if the operating
mode
Static
is selected.
Netmask:
Enter the network netmask - only if the operating mode
Static
is selected.
