Installation
G&D DP1.2-MUX3-ATC ·
8
English
DP CPU:
Use the DisplayPort cable to connect the computer’s video output to this
interface.
Connection to up to two networks
If desired, connect the network interfaces with up to two local networks to access
the web application
Config Panel
from the networks and to send SNMP traps or sys-
log messages to these networks.
Network A:
Plug in the category 5e (or higher) twisted-pair cable, which is available as
an accessory. Connect the other end of the cable to a local network.
Network B:
Plug in the category 5e (or higher) twisted-pair cable, which is available as
an accessory. Connect the other end of the cable to a local network.
Connecting the power supply
Main Power:
Connect a power cable to a mains socket and this socket.
Red. power:
If desired, connect another power cable to a mains socket and this
socket. This provides the device with a second, redundant power supply.
NOTE:
Multichannel devices provide further
DP CPU x.y
interfaces above this inter-
face.
Use further DisplayPort cables to connect this interface to further graphics outputs
of the computer.
Figure 4: Interface for connecting the power supply
Figure 5: Interface for connecting the power supply
USB 3.0
Line In PS/2 K/M USB K/M
USB 3.0
Line In PS/2 K/M USB K/M
DP Monitor
USB 3.0
Line In PS/2 K/M USB K/M
CPU In 1
Speaker
PS/2 K/M
RS232
USB K/M
Network A
Network B
CPU In 2
DP CPU 2
DP CPU 1
CPU In 3
Dig. Audio Out
Power
Red.
Main
Ready
Ident.
System
Fail
Status
DP CPU 2
DP CPU 1
DP CPU 3
USB 3.0
Line In PS/2 K/M USB K/M
USB 3.0
USB K/M
Main Power
Red. Power
CPU In 3
