94
From the opening screen, hold down the [ /+] key to display the SBUS servo screen.
Opening screen
SBUS servo screen
Press and hold the [ /+] key
Press and hold the [Esc/Page] key
(1) RECALL
Load the setting data of S.BUS servo connected to
GPB-1. Move the cursor to "RECALL" by pressing
the [ /+] or [ /-] key. Press the [Enter] key to enter
the recall mode. When "EXECUTE: Enter (1 sec)" is
displayed, press and hold the [Enter] key for about 1
second. To cancel, select press [Enter] key or [Esc/
Page] key to exit the recall mode.
- "COMPLETED !" is displayed on the screen and the ser-
vo’s ID cord and currently set channel are read.
- If "FAILED !" is displayed on the with the servo is not be-
ing performed normally. Please turn off the power of the
GPB-1, connect the servo again, turn the power on and per-
form "RECALL" again.
Press the [ /-] key
Press the [Enter] key
Press and hold
the [Enter] key
S.BUS / S.BUS2 servo recall, writing, initialization
Summary of Contents for CGY755
Page 112: ......