FUTABA CGY755, Manual

Page: 61 / 112

62
GOV. BASIC screen 2/6
Go to 3/6 from any cursor position
(3) Pole Num.: Pole number
This parameter is used when using a direct phase sensor attachment
to a brushless motor lead. Input the motor pole count as specified by
the brushless motor manufacturer. When using any revolution sensor
other than a direct phase sensor type, set the pole number to 2 p.
Note : For nitro use, set to 2 p.
Note : The input signal range of the CGY is 0.0 v - 3.0 v. Exceeding this
voltage range may cause damage to the CGY.
Setting ranges: 2 ~ 24 P Initial value: 2 P
(4) Servo Type
Select the throttle servo type. Digital servos offer the best response.
Move the cursor to "Servo Type" by pressing the [ /+] or [ /-] key and
press the [Enter] key to enter the setting mode. Select the servo type with
the [ /+] or [ /-] key. Pressing the [Enter] key exits the setting mode.
Setting: Analog / DG:1520 Initial setting: Analog
WARNING
The servo type parameter within the CGY must match the type of
servo you are using. Incorrect settings may damage the CGY or the
servo. An incorrect setting may also result in the loss of control
during flight.
From 1/6
CAUTION
There is a danger of heavy loads being applied
to the rotor rotating at high speed. Dropout of the
rotor blade, damage of the head, etc., may oc-
cur. Do not set the rotation speed to a value that
exceeds the strength limit of the helicopter and
rotor.