96
Change servo type DG:1520 DG:760)
Change the servo type (760 μS / 1520 μS) to the con-
nected servo. Move the cursor to the type under "SE-
LECT" by pressing the [ /+] or [ /-] key. Press the [Enter]
key to enter the changing mode. When "EXECUTE:
Enter (1 sec)" is displayed, use the [ /+] or [ /-] keys
to select the servo type to change, press and hold the
[Enter] key for about 1 second. To cancel, select press
[Enter] key or [Esc/Page] key to exit the changing mode.
- "COMPLETED !" is displayed on the screen and The type
display on the left side is updated to the changed type. Ini-
tialize each parameter.
- If "FAILED" is displayed on the screen, please go again
or turn the power off and confirm the connection, then turn
the power on and perform the operation again.
Press the [Enter] key
Press and hold
the [Enter] key
Change servo type
Changing the servo pulse width from 1520 to 760 is possible with the servo type
function.
Display of "servo type" when reading
* When "RECALL" is executed, the servo type name is displayed on the left side of the screen,
and the current 760 or 1520 type is displayed below it. The S.BUS servo not supporting servo type
change displays "Unsupported".
* A new S.BUS servo (example: HPS-H700) that can set both parameters for swash (SWH: 760)
and Rudder (RUD: 760) is loaded first, the servo type name on the left side, DG: 1520, SWH: 760 is
displayed under "SELECT" on the right side. Changing the servo type from SWH: 760 to RUD: 760
will display RUD: 760 under the servo type name the next time you load it. However, if you change
the parameter of RUD: 760, the subsequent reading will show SWH: 760. Please mark so that the
set servo type can be determined.
The S.BUS servo which can change the servo type of 760 μS and 1520 μS is indi-
cated as "SELECT" on the right side and DG: 760 or SWH 760 below it. The servo
whose servo type can not be changed is indicated as "Unsupported" in the servo
type name.
* Current type
Updated servo type
Summary of Contents for CGY755
Page 112: ......