57
R
UD.
B
ASIC
M
ENU (RUDDER GYRO BASIC SETTING)
In the
"
RUD. BASIC
"
menu, you make the basic setting of the rudder gyro.
"
RUD. BASIC
"
screen from the
"
BASIC MENU
"
screen.
Setting on transmitter side
The following transmitter setting example shows the case of using Futaba GY gyro
mixing. Please read in accordance with your system.
1.
Enable rudder gyro mixing.
2.
In the gyro mode select "GY".
3.
Temporarily set the gyro sensitivity of normal condition and hold condition to AVCS
75%. Also, temporarily set the gyro sensitivity of all idle up conditions to AVCS 50%.
4.
Set the channel angle setting function (ATV / AFR / EPA) of the rudder channel and
sensitivity setting channel to 100%.
5.
Temporarily set the D/R function of the rudder channel to 75% both left and right.
6.
We recommend that you temporarily set the EXP function of the rudder channel to
about -30% (mild side 30%) need to clarify what is meant by mild side.
WARNING
Do not connect the tail rotor servo to the gyro until the servo type
has been selected. Operating the servo using the incorrect setting
may damage the CGY or the servo.
Do not operate with the linkage connected until the "Srv. Limit"
function correctly sets the servo limit point. If the servo operates be-
yond the linkage operating range, there is a danger of either the servo
or helicopter being damaged.
* Please note that these are only the temporary settings. Final values will be de
-
termined during flight.
Summary of Contents for CGY755
Page 112: ......
