27
SETUP & PREPARATION
Horizontal position to vertical position
1.
Remove the rear leg (13) from its current position
(fig. 45).
2.
Release the horizontal lock latch
3.
Hold the hydraulic cylinder handle (3) and slowly stand the assembled beam on the end
plate in the vertical position (fig. 46).
4.
Move the Lock pin and R-clip from the upper hole and insert the lock pin into the lower
hole. Ensure the beam is locked in the vertical position (fig. 47).
Horizontal lock latch
Upper Hole
Lower Hole
Upper Hole
Fig. 45
Fig. 46
Fig. 47