17
ASSEMBLY (cont.)
Upper Hole
Lower Hole
Upper Hole
5.
Move the Lock pin and R-clip from the upper hole and insert the lock pin into the lower
hole. Ensure the beam (16) is locked in the vertical position (fig. 15).
Fig. 15
Sleeves
Split Pin
Bolt & Washer
Nut & Washer
Axle
Upper Bracket
Lower Bracket
Bearing
Anti-dust Washer
Axle Nut
Wheel Cap
Washer
Wheel Axle
6.
Place the axle (24) below the upper
bracket. Align the holes in the lower
bracket and upper bracket. Insert each bolt
with washer from the underside. Secure in
place with a washer and nut (fig. 16).
Note:
Only tighten after all 4 bolts are
assembled in place.
Wheel assembly (Second wheel)
Tools required (not supplied):
¥ 32mm Socket with ratchet, Long nose pliers, Soft face hammer
1.
Use assembly hardware
6
2.
Adjust the pallet to allow enough space to assemble the second wheel (11).
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2
Fig. 16