22
ASSEMBLY (cont.)
Log cradles assembly
Before assembly place the log splitter in the Horizontal position, refer page 28, steps 1 - 3.
Tools required (not supplied):
¥ 19mm Socket with ratchet, 18mm ring/open end spanner.
1.
Use assembly hardware
11
2.
Align the engine side log cradle (23) to
the holes on the beam mounts. Insert four
bolts with washer through log cradle (23)
and beam mounts. Secure in place with a
washer and nut (fig. 28).
Note:
Fastening the log cradle to the Inside
Holes of the beam mounts will give
the log cradle a slight incline, while
the Outside Holes should be used if
attaching the log table (14) as this will
give a horizontal position.
3.
Follow the same procedure to assemble the right side log cradle (22).
Wheel Guard
(engine side)
Inside
Mounting Hole
Outside
Mounting Hole
Log Cradle
(engine side)
Log Table
Flat Washer
Spring Washer
Nut
Dome Head
Bolts
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2
Muffler assembly
Tools required (not supplied):
¥ 13mm Ring/open end spanner
1.
Remove the plastic cover by removing the
nuts and washers (fig. 27)
2.
Place the muffler (25) over the opening
and reinstall the washer and nuts.
Fig. 27
Fig. 28