15
ASSEMBLY (cont.)
3.
Remove the anti-dust sleeves from a wheel
(11) while keeping the bearings and anti-
dust washer in place (fig. 10).
4.
Slide a wheel (11) with valve stem facing
out onto the axle (24) on one side, then
place the wheel washer against the
bearing. With the 32mm socket tighten the
axle nut fully in place (fig. 11).
5.
Turn the wheel (11) to ensure the bearing is
seated correctly.
Axle
Tools required (not supplied):
¥ 19mm Socket with ratchet, 18mm ring/open end spanner, 13mm ring/open end
spanner x 2
1.
Use assembly hardware
5
Split Pin
Bearing
Anti-dust Washer
Axle Nut
Wheel Cap
Washer
Bearing
Anti-dust Washer
Sleeve
Split Pin
Bearing
Anti-dust Washer
Axle Nut
Wheel Cap
Washer
Bearing
Anti-dust Washer
Sleeve
Fig. 10
Fig. 11
6.
Loosen the axle nut until it is loose enough to turn the wheel (11) with your fingers, then
retighten the axle nut
finger tight
only.
7.
Insert the split pin through the hole in the axle (24). Bend and spread the prongs in
opposite directions with long nose pliers so the axle nut will not come off, making sure
the wheel (11) spins freely.
8.
Align the wheel cap against the wheel hub. Tap lightly with a soft face hammer to
ensure the wheel cap is installed on the wheel hub correctly.
Note
: Only assemble one wheel (11) at this stage, the other side wheel (11) will be
assembled after mounting the axle (24) to the log splitter.
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2