23
ASSEMBLY (cont.)
Log table assembly
Tools required (not supplied):
¥ 16mm Ring/open end spanner.
1.
Use assembly hardware
12
2.
Ensure the log cradle is in the horizontal
position before attaching the log table
(14). Refer page 22,
Log cradles
assembly
section for further details.
3.
Place the log table (14) over the log cradle
aligning the four holes. Insert bolts, secure
with flat washers, spring washers, and nuts
(fig. 29).
Wheel Guard
(engine side)
Inside
Mounting Hole
Outside
Mounting Hole
Log Cradle
(engine side)
Log Table
Flat Washer
Spring Washer
Nut
Dome Head
Bolts
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2
Support leg (rear) assembly
1.
Place the support leg (13) into is mounting bracket in
the lowermost position, hold in place with both
pins (fig. 30).
NOTE:
This can be also moved up to a transport position,
covered in The
Features and Controls
section.
Fig. 29
Fig. 30