14
ASSEMBLY (cont.)
Drawbar assembly
Tools required (not supplied):
¥ 18mm Ring/open end spanner x 2.
1.
Use assembly hardware
3
2.
Insert the drawbar (19) into the beam bracket. Align the holes in the drawbar (19) and
beam bracket. Insert each bolt with washer from one side. Secure in place with flat
washers, spring washers, and nuts (fig. 8).
Bolt & Washer
Beam Bracket
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2
Wheel assembly (First wheel)
Tools required (not supplied):
¥ 32mm Socket with ratchet, Long nose pliers, Soft face hammer
1.
Use assembly hardware
4
2.
Remove the two anti-dust sleeves from the
axle (24) (fig. 9).
Sleeves
Split Pin
Bolt & W
asher
Nut & W
asher
Axle
Upper Bracket
Lower Bracket
Bearing
Anti-dust W
asher
Axle Nut
Wheel Cap
Washer
Wheel Axle
Ø18 x 135
x 1
R-Clip
x 1
M10 x 35 x 6
M12 x 35 x 8
M12 x 80 x 2
x 1
x 1
6 x 40
x 2
M8 x 20 x 2
M12 x 30 x 4
Axle Nut & Washer
x 1
Split Pin 4 x 50
x 1
x 1
M8 x 20
x 8
M10 x 25 x 4
Wheel Cap
Roll Pin
U-shaped Lock Pin
Washer & Sping
Pivot pin
M10 x 25 x 2
Fig. 8
Fig. 9