12
ASSEMBLY (cont.)
R-Clip
Washer
Pivot Pin
Beam
Assembly
Engine
Assembly
4.
With the hole in the beam pivot bracket
aligned with the pivot hole on the pivot
mount, insert the pivot pin using a soft face
hammer and secure with the washer and
R-clip (fig. 3).
5.
Disassemble the support leg (7) from the
log splitter by removing the 3 bolts and
bracket (fig .1).
Control lever
1.
The lever is shipped hanging from the valve
on the handle link. Remove the pin and
split pin from the control lever (1), move
the control lever (1) to the vertical Neutral
position (fig. 4).
2.
Reinstall the pin and split pin to the control
lever (1).
50mm
Hydraulic cylinder handle
Tools required (not supplied):
¥ 16mm Ring/open end spanner.
1.
Loosen the two nuts on the cylinder
handle (3)
.
2.
Position the cylinder handle (3) horizontally
approximately 50mm from the end of the
hydraulic cylinder (2) and fully tighten using
the 16mm spanner (fig. 5).
50mm
Hydraulic Cylinder
Handle
Fig. 3
Fig. 4
Fig. 5