Fukuda Denshi DS-7001, Service Manual

Page: 65 / 151

Cleaning
Cleaning the Housing
Clean the housing using tightly squeezed gauze or an absorbent cotton cloth dampened with
alcohol or a neutral cleanser.
CAUTION
l
Clean the equipment frequently so stains can be removed easily.
l
l
l
l
l
To prevent injury, it is recommended to wear gloves when cleaning
the equipment.
Do not allow liquids or cleaning solution to enter the monitor or
connectors.
Do not use organic solvents, thinner, toluene and benzene to avoid
damaging the resin case.
Do not polish the housing with abrasive or chemical cleaner.
When sterilizing the entire room using a spray solution, pay close
attention not to have liquids get into the monitor or connectors.
l
Use only neutral detergent to clean the housing. Do not use
chemical cloth, scrub brush, abrasive, polishing powder, hot water,
volatile solvent and chemicals (cleanser, thinner, benzine, benzol,
and synthetic detergent for house and furniture), or sharp-edged
tools. The surface resin coating may be damaged, resulting in
discoloration, scratches, and other problems.
Cleaning and Disinfecting the SpO
2
Transducer
Ÿ
Ÿ
Ÿ
Do not soak the sensor in water or antiseptic solution.
Wipe the DURASENSOR with disinfectant such as 70% alcohol. Do not disinfect by
applying radioactive rays, steam, or ethylene oxide.
OXISENSOR is a disposable sensor. Do not reuse or attempt resterilization.
4 － 3