Fujitsu SPARC Enterprise T5140, Product Notes

Page: 86 / 138

76 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
6983799
6981373
6946636
6913105
6908024
6722602
6663105 When connected to OS console via ILOM, input or
display to console may not be enabled. And at this
time, output from Solaris OS to console may fail. Note - Fixed in System Firmware 7.3.0.c or later.
After the system stop, disconnect the power cord and
then reconnect the power cord.
6983799
6981373
6946636
6908024
6722602
6663105 The login from SSH client to ILOM fails. Or, you
may fail to execute the ILOM command.
When this problem occurs, the following problems
may occur subsequently.
1. The login from SSH client (Secure Shell) to ILOM
fails.
2. The forcible dump order to OS fails.
3. The power-off order from ILOM fails.
4. The power-on order from ILOM fails.
5. The Solaris OS condole can not be obtained. Or,
you can not enter anything after entering "y".
Note - Fixed in System Firmware 7.3.0.c or later.
Power off the system, disconnect the power cord, wait
for about 180 seconds, and then reconnect the power
cord.
6972360 With System Firmware 7.2.10 or later, when you
connect the T5240 server which has the 1.6 GHz
CPU and of 8-disk configuration to the 100V power
supply and power on the system, a message might be
displayed in the Solaris OS system log. Also,
warning will be displayed in the
prtdiag -v
command execution result. For details, see “When the
T5240 Server Connected to the 100V Power Supply
and Powered On, a Message Might Be Displayed in
the Solaris OS System Log (CR 6972360)” on
page 78
.
Note - Fixed in System Firmware 7.3.0.c or later.
None.
Due to the ILOM firmware bug, the input voltage
threshold value (noncritical) of the system which has
the 1.6 GHz CPU and of 8-disk configuration contains
an error.
If no faults are detected by executing commands like
show faulty command, ignore the output messages and
the displayed warnings.
6962499 After you remove/insert the power cord and while
POST is running, the "
/SYS/XXXXX prom is
unreadable or corrupted
" message may
appear and stop at
ok
prompt. For details, see “After
the Power Cord Removal/Insert, an Error Message
May Appear during the POST (CR 6962499)” on
page 79
.
Note - Fixed in System Firmware 7.3.0.c or later.
Take 180 or more seconds for each of the intervals
between the system power-off and the power cord
removal, and between the removal and insertion of the
power cord.
6922544 When the timezone of the ILOM time has been set to
other than GMT, if you set the ILOM time and then
remove and insert the power cord, the ILOM set time
and the Solaris OS startup time may become
inaccurate. Note - Fixed in System Firmware 7.3.0.c or later.
After you set the ILOM time, perform the ILOM reset
before you remove and insert the power cord and start
the Solaris OS.
TABLE A-4
Issues Fixed in System Firmware 7.3.0.c or Later (Continued)
CR ID Description Workaround