Fujitsu SPARC Enterprise T5140, Product Notes

Page: 117 / 138

Appendix A Fixed Issues 107
showfaults
command output example:
Workaround: Identify and replace the faulty DIMM module.
Fixed in System Firmware 7.1.7.f or Later
Last POST Run: Wed Jun 4 06:14:17 2008
Post Status: Passed all devices
ID FRU Fault
1 /SYS/MB SP detected fault: /SYS/MB/CMP0/MCU2 Forced fail
(DRAM init)
TABLE A-10
Issues Fixed in System Firmware 7.1.7.f or Later
CR ID Description Workaround
6768857 In rare cases, the first " start /SYS " ( poweron )
command after the power cord has been connected
may cause the following message to be output, and
the system to be powered off:
V_VTTL at /SYS/MB has exceeded low non-
recoverable threshold.
If this occurs, execute "
reset /SP
" (
resetsc
),
and then execute the "
start /SYS
" (
poweron
)
command again.
Note - Fixed in System Firmware 7.1.7.f or later.
None.
6757022 Resetting the service processor while the host is
powered on can cause the host to crash. Note - Fixed in System Firmware 7.1.7.f or later.
Do not reset the service processor while the system is
powered on. If you encounter this issue, power cycle
the server.
6731227 Two circumstances can cause a logical domain to
hang when reassigning I/O branches from the
primary domain (control domain) to a guest domain
(I/O domain):
For details, see
“A Logical Domain May Hang When
Reassigning I/O Branches From the Control Domain
to a Guest Domain (CR 6731227)” on page 109
.
Note - Fixed in System Firmware 7.1.7.f or later.
For details, see “A Logical Domain May Hang When
Reassigning I/O Branches From the Control Domain
to a Guest Domain (CR 6731227)” on page 109
.
6731027 Under certain conditions, the system might not power
off when the Solaris OS is halted. The system might
appear unresponsive in this case with no messages in
at the system console or on the SC console. Note - Fixed in System Firmware 7.1.7.f or later.
Power off the system using one of the following
methods:
• The ILOM
stop/SYS
command
• The ALOM poweroff command