Fujitsu SPARC Enterprise T5140, Product Notes

Page: 131 / 138

Appendix B Minor Cases 121
6739602 If the logdetail property in
/SP/clients/activedirectory
is set to a
value other than "none," the following authentication
error message may be displayed even if Active
Directory is set to disabled (state = disabled):
sc> ActDir | critical: (ActDir)
authentication status: auth-ERROR
If Active Directory is set to disabled, ignore the
message.
6738510 Specifying the
-t
option in certain commands
(
create
,
delete
,
exit
,
load
,
reset
,
set
,
start
,
stop
,
version
) may cause a forced logout
from the ILOM CLI.
None.
6726663 In ILOM mode, or through access to the ILOM Web,
it may be possible to change the system time when
the system is powered on. In ILOM mode, be sure not to change the properties
displayed below at power on so as not to change the
system time directly or enable NTP services.
-> show /SP/clock
/SP/clock
Targets:
Properties:
datetime = Wed Dec 3 06:22:48 2008
usentpserver = disabled
Commands:
cd
set
show
->
6723410 If you repeat in sequence a login to the service
processor, executing a command, and logging out,
logout may fail. If this problem occurs, terminate the login session on
the client from which you have accessed the service
processor.
6659980 When you restarted Solaris OS, OpenBoot PROM
may output the error message "
ERROR: Unable
to disown USB port 3
."
For details, see “When You Restarted Solaris OS,
OpenBoot PROM May Output the Error Message
(CR 6659980)” on page 126
.
None.
This message has no impact on the system and the
USB device, and can be safely ignored.
TABLE B-1
Firmware and General Software Events (Continued)
CR ID Description Workaround