Fujitsu SPARC Enterprise M4000, Reference Manual, Page: 141 / 444

setaltitude(8)
System Administration 141
NAME setaltitude - set the altitude of the system
SYNOPSIS setaltitude
-s
key=value
setaltitude
-h
DESCRIPTION The
setaltitude
(8) command sets the altitude of the system.
The specified value becomes valid when the circuit breakers of the system are
switched on again.
Privileges
You must have
platadm
or
fieldeng
privileges to run this command.
Refer to
setprivileges
(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
■
If the altitude of the system is set, any abnormality in the intake air temperature
can be detected quickly. If the altitude of the system is unknown, set a high
value. However, even if no altitude is set for the system, any abnormality in
temperatures such as the CPU temperature can still be detected, so the system
would not be damaged by a fatal error.
■
When the
showaltitude
(8) command is executed, the current settings are
displayed.
EXAMPLES
EXAMPLE 1
Sets the altitude of the system to 1000 m.
-h
Displays usage statement. When used with other options or
operands, an error occurs.
-s
key=value The item to be set is specified by key. The following value can be
specified:
altitude
Sets the altitude of the system.
Specifies the altitude of the system in value in units of meters (
m
).
An integer equal to or greater than 0 can be specified, and the
specified value is rounded off to the nearest hundred meters.
The value may be rounded up to the nearest hundred meters.
The default value is 0 meters.
XSCF>
setaltitude -s altitude=1000
1000m