Chapter 2 Components
2.4 2.5" Type Drive Enclosure
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
67
Copyright 2011 FUJITSU LIMITED
P3AM-3042-08ENZ0
2.4
2.5" Type Drive Enclosure
2.5" type drive enclosures contain 2.5" disks installed in the front, and expanders and power
supply units (with fans) in the rear.
2.4.1
Front View
■
With flange cover
Figure 2.26 Front view of 2.5" type drive enclosure (with flange cover)
IMPORTANT
•
Each enclosure has two power supply units (PSU#0 and PSU#1). The
power cords must be connected to the inlets of both power supply units.
•
When connecting the power cord right after it is disconnected, wait for
the STATUS LED of the power supply unit is turned off completely (about
10 seconds) before connecting it again.
DE_No. label
Indicates the drive
enclosure No.
Flange cover
Disk
Up to 24 can be installed in the ETERNUS DX60/DX80/DX90.
POWER LED
Glows green
( )
when the power is
turned on.
READY LED
Glows green
( )
when device is available
for use.
FAULT LED
Glows orange
( )
when an internal device part
abnormality has been detected. Blinks orange
( )
when a predictive error has been
detected.
IDENTIFY LED
Blinks blue ( ) or turns off ( ) as ordered via
GUI to identify the enclosure installation
locations.
DISK FAULT LED
Glows orange ( ) when a disk has failed.
Blinks orange ( ) according to the VDS (Microsoft Virtual Disk Service) commands.
DISK READY LED
Glows ( ) or blinks green ( ) when disks
are operating normally.
