Fujitsu ETERNUS CS800 S5, User Manual

Page: 344 / 634

Notifications Configuration
330
U41840-J-Z125-7-76
I
If you define a single community and set both the IP address and network mask
to 0.0.0.0 (or leave both blank), then IP address-based access control is
disabled. In this case, the SNMP agent is accessible from any IP address.
I
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick tip
icon
[?] located near the IP address field.
4. In the Access Type drop-down box, select the access type for the community:
●
Get - Allows SNMP get operations.
●
Get/Set - Allows both SNMP get and put operations.
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply .
Deleting a Community
Delete an SNMP community if you no longer want the ETERNUS CS800 to belong to a
group of devices that are monitored by a common management station.
To delete a community, select the community and click Delete .
I
You can select multiple communities to delete at once.
Test
The SNMP Test page allows you to send a test SNMP trap to verify that SNMP is correctly
configured on the ETERNUS CS800.
To access the SNMP Test page, on the SNMP page, click the Test tab (see Figure 205 ).