Fujitsu ETERNUS CS800 S5, User Manual

Page: 399 / 634

Replication Actions
U41840-J-Z125-7-76
385
Replication Service
The replication service controls replication and failback traffic on the ETERNUS CS800.
You can pause each replication target independently.
●
Click Pause next to a target to pause all replication and failback traffic to that target.
If a replication job is currently in progress, the system continues to replicate the current
block of data. The process of replicating the current block can take up to 15 minutes to
complete. After the block has completed replication, the system pauses replication.
I
If you pause a replication job that is in process, a Failure event is logged in the
replication report (see
"Reports" on page 387 ).
●
Click Resume next to a target to resume all incoming and outgoing replication and
failback traffic to that target.
If a replication job was in progress when replication was paused, the replication job
continues.
Replication State
The replication state applies to all NAS shares or VTL partitions on the ETERNUS CS800
that are eligible for replication (that is, all deduplicated shares or partitions).
I
The Replication Actions page may appear busy for a few moments when enabling
or disabling the replication state. Wait for the process to complete before performing
other actions.
●
Click Enable to enable replication for all shares or partitions.
●
Click Disable to disable replication for all shares or partitions.
If a replication job is currently in progress, the system continues until the entire repli-
cation job is complete. After the replication job has completed, the system disables
replication. The system will not be able to replicate data for any shares or partitions until
you click
Enable .
I
To disable replication for a single share or partition, select it on the Replication
> Send page and click Edit . Clear the Enable replication and the Enable
scheduled replication check boxes, and then click Apply . For more
information, see "Replication State" on page 385 .