Fujitsu ETERNUS CS800 S5, User Manual

Page: 165 / 634

Configuration Wizards VTL Wizard
U41840-J-Z125-7-76
151
Step 5: Map Remote Hosts
1. Enter information about the host access group (see Figure 96 ):
●
Group Name - Enter a name for the group.
●
Partition - Select the partition to associate with the group.
●
Remote Host - Select the host (initiator) to associate with the group.
●
Target - Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system. A dark border
displays around the currently selected target.
I
To change the LUN numbers assigned to a device, or to map virtual devices to
a host, use the
Configuration > VTL > Remote Host Access > Remote Host
Mapping page (see "Remote Host Mapping" on page 223 ).
2. (Optional) Select the Use CCL check box to use the Command and Control LUN.
I
The CCL (Command and Control LUN) is not used in most environments. This
option is recommended for host access groups that contain an HP-UX host. It
can also be used if hosts that are not assigned to any host access group exist
in the SAN. The CCL is accessible to hosts only through LUN 0.
V
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Customer Support
before you enable this option.
3. Click Add .
4. (Optional) To map additional hosts, repeat Steps 1–3.
5. Click Next to continue.