Fujitsu ETERNUS CS800 S5, User Manual

Page: 89 / 634

Installing the Rack Handling Instructions for the Rack
U41840-J-Z125-7-76
89
●
4 x M6 lozenge nut (two at the front, two at the rear)
●
6 x countersunk screw (for attaching the tilting protection)
●
1 x fixing plate (for attaching the rear part of the tilting protection)
●
1 x angled Torx screwdriver TX25
●
1 x marking template (for 600 mm & 700 mm wide racks)
Preparation
●
Screw the leveling feet (1) into the threaded bushings on (2) the underside of the tilting
protection.
●
Mark the positions of the lozenge nuts (3) on the front and rear of the rack using the
supplied template for 600 mm or 700 mm rack widths
I
Start and end point when applying the template are shown as red bars in (see
pos. (3)
in the picture at the bottom of this page).
●
Insert the lozenge nuts (3) into the T groove of the profile.
1
3
3
1
2