Fujitsu AIRSTAGE J-IIIL, Design & Technical Manual

Page: 617 / 904


Entering function setting mode
NOTE: Be sure that all the procedures described in "Preparation" on page 07-15 are completed.
• The position of the MANUAL AUTO button varies depending on the model. For the actual position
of the button on each unit, refer to the operation manual.
• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-
played. In this case, release the button or turn off the power.
1. Press and hold the MANUAL AUTO button for 3 seconds.
3 short beeps
MANUAL
AUTO
MANUAL AUTO
IR receiver unit
2. While holding down the FAN and the SET TEMP. buttons, press the RESET button. The
function setting mode will be activated.
SET TEMP. ( )
RESET
FAN
Function setting
mode display

Selection and confirmation of custom code
1. In function setting mode display, press the SET TEMP. or button to select the custom
code that matches the setting with the indoor unit. By selecting the appropriate custom code,
the communication between the indoor unit and the wireless remote controller become possi-
ble.
Custom code
( - - - )
The initial setting is " "
1-4. Address setting by remote controller
- (07-17) -
1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS