100
FMPC
8.2.15 Paper Feed Length Adjustment
(452)
[Selection]
“4 Setup and Maintenance” - “5 Printer Adjustment/
Maintenance” - “2 Paper Feed Length Adjustment”
[Procedure]
Adjustment the paper feed length.
1
Select the ID number of the magazine to be
adjusted from the list on the screen and click it.
2
Make sure the value in the “Set value (feed
length)” is “254.0”.
3
Enter the fine adjustment feed length value
indicated on the label attached to the magazine
in the “Fine adjust value”.
4
In Menu “455 Paper Feed”, feed paper with
127mm and 381mm feed lengths.
5
Measure the feed lengths of the sheets of paper
fed out and calculate the adding value using the
formula below.
Adding Value = 254– (Measured Value of
381mm – Measured Value of
127mm)
<Example>
Measured Value of 381mm = 380.0mm
Measured Value of 127mm = 126.4mm
Adding Value = 254 – (380 – 126.4) = 0.4
6
Add the “Adding Value” to the value in the “Fine
adjust value” and enter it in the “Fine adjust
value” box.
<Example>
Fine adjust value = 1.0mm
Adding Value = 0.4mm
New Fine Adjust Value = 1.0 + 0.4 = 1.4
7
In Menu “455 Paper Feed”, feed paper with
127.0mm feed length.
8
Measure the feed length of the sheet of paper
fed out and calculate the offset adding value
using the formula below.
Offset Adding Value = 127 – “Measured Value
of 127mm”
<Example>
Measured Value of 127mm = 126.6mm
Offset Adding Value = 127 – 126.6 = 0.4mm
9
Add the offset adding value to the value in the
“Offset value” and enter it in the “Offset value”
box.
10
Repeat Steps 1 to 9 for all paper magazines.
11
Click [OK].
• Operation returns to the “4 Setup and
Maintenance” screen.
distributed by www.minilablaser.com
