Fuji Xerox DocuPrint M218 fw, User Manual

Page: 339 / 468

Using the Operator Panel Menus and Keypad 338
• Initialize NVM
Purpose:
To initialize network data stored in Non-Volatile Memory (NVM). After executing this function and
rebooting the printer, all network settings are reset to their default values.
Values:
Fax Settings
Use the
Fax Settings
menu to configure the basic fax settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Ans Select
Purpose:
To select the default fax receiving mode.
Values:
• Auto Answer Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call.
The interval can be specified within the range of 0 to 255 seconds. The default is 0 second.
Yes Initializes the network data stored in NVM.
No* Does not initialize the network data stored in NVM.
TEL Mode Automatic fax reception is turned off. You can receive a fax by picking
up the handset of the external telephone, pressing the remote receive
code, and then pressing
( Start ) button.
FAX Mode* Automatically receives faxes.
TEL/FAX Mode When the printer receives an incoming fax, the external telephone
rings for the time specified in
Auto Ans. TEL/FAX
, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.
Ans/FAX Mode The printer can share a telephone line with an answering machine. In
this mode, the printer will monitor the fax signal and pick up the line if
there are fax tones. If the phone communication is using serial
transmission in your region, this mode is not supported.
DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure
the fax setup to monitor for that specific ring pattern.