13 Using the iFax Service
130
Usi
n
g the
iFax Service
13
z
[POP3 Server Port Number]
Enter a value in the range from 1 to 65535.
z
[POP3 Server Check Interval]
Set the interval for checking e-mail on the POP3 server.
z
[POP3 Server Login Name]
Enter the name to login to the POP3 server.
z
[POP3 Server Password]
Enter the same password twice in [New Password] and [Re-enter Password]. If you
do not set the password, leave it blank and select [Save].
z
[POP Receiving Password Encryption]
Select [On (APOP)] to encrypt the password.
3) Select [Save].
4) Select [Close].
4
Configure the e-mail transmission
1) Select [SMTP Server Settings] and then set the following items for the SMTP
server.
z
[SMTP Server Setup]
Select from [By IP Address] or [By Server Name].
z
[SMTP Server IP Address]
Enter an IP address if [By IP Address] has been selected for [SMTP Server Setup].
Note
•
Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" must be a numeric value in the
range from 0 to 255. However, 224-255.xxx.xxx.xxx, and 127.xxx.xxx.xxx cannot be used.
•
When you make an entry mistake, press the <C> (Clear) button and enter again.
•
When moving to the next value without entering all 3 digits, select [Next].
z
[SMTP Server Name]
Enter a server name if [By Server Name] has been selected for [SMTP Server
Setup].
z
[SMTP Server Port Number]
Enter a value in the range from 1 to 65535.
Note
•
This configuration is not necessary if [SMTP] has been selected for [E-mail Receive
Protocol] and has already been configured.
z
[E-mail Send Authentication]
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note
•
If [POP before SMTP] has been selected, the POP3 settings must be set.
z
[SMTP AUTH Login Name]
Set this item if [SMTP AUTH] has been selected for [E-mail Send Authentication].
z
[SMTP AUTH Password]
Set this item if [SMTP AUTH] has been selected for [E-mail Send Authentication].
Enter the same password twice in [New Password] and [Re-enter Password]. If you
do not set the password, leave it blank and select [Save].
2) Select [Close].
5
Configure the Domain filter.
1) Select [Domain Filter] and set the following items.
