Fuji Xerox ApeosPort-V 4070, Administrator'S Manual

Page: 70 / 719

3 Maintenance
70
M
a
inte
na
nc
e
3
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front door.
Note • If the front door is not closed completely, a message appears and the machine will remain paused.
Replacing Staple Cartridge
(for C3 Finisher or C3 Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the staple cartridge needs to be replaced, a message appears on the touch screen.
When this message appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
• To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher front door.
2
With grasping the lever [R1] of the staple
cartridge holder, pull the holder to the right,
towards you.
Message Solution
The Staple Cartridge [R1] is running out of
staples. Check the Staple Cartridge [R1] and
order staples. Prepare new staples.
Note • Staples cannot be replaced yet.
The Staple Cartridge [R1] is out of staples or not
fully inserted. Check the Staple Cartridge [R1]. Replace staples with new ones.