Force SPARC/CPCI-520G, Technical Reference Manual

Page: 76 / 134

SCSI #2 Configuration I/O-52x(G) Installation
Page 62 SPARC/CPCI-52x(G)
5.5 SCSI #2 Configuration
Note: Correct SCSI bus selection: The I/O-52x(G) provides a
second SCSI bus, SCSI #2. Its configuration is described as follows.
The I/O-52x(G)’s SCSI #2 bus is only available at the I/O-52x(G)’s
CompactPCI J5 connector.
Valid
configuration There is only 1 valid I/O-52x(G) SCSI #2 bus configuration:
• The I/O-52x(G) is located at an endpoint of the SCSI #2 bus, the
SCSI #2 bus is extended via the CompactPCI backplane:
The SCSI #2 bus is always terminated at the SCSI #2 controller.
5.6 Ethernet #2 Configuration
Note: Correct Ethernet selection: The I/O-52x(G) provides the
following 2 Ethernet #2 interfaces:
• via a TPE #2 interface connected to a front-panel RJ-45 connector
• or an MII #2 interface available at the CompactPCI J5 connector
Ethernet address
and host ID For the SPARC/CPCI-52x(G) exists only 1 ethernet address and host ID,
see "Ethernet Address and Host ID" section of the Base-520(G)’s instal-
lation section. Therefore you can use the Ethernet #2 TPE or MII inter-
face of the I/O-52x(G) only in a separate network according to
Ethernet #1 TPE or MII of the Base-520(G).
I/O-52x(G)
Front
panel CompactPCI
backplane
SCSI #2
controller
Endpoint of
SCSI #2 bus