Force SPARC/CPCI-520G, Technical Reference Manual

Page: 123 / 134

FORCE OpenBoot Enhancements System Configuration
SPARC/CPCI-52x(G) Page 109
set-conf
( byte sensor# — ) stores the value byte in the configuration register of the tem-
perature sensor specified by sensor#, sensor# =
1
,
2
. The contents of the
status register data is left on the evaluation stack.
watch-temperature
( — ) puts both temperature sensors into interrupt mode and ini-
tiates continous temperature conversion.
monitor-t
( sensor# — ) monitors the actual temperature of the temperature sensor speci-
fied by sensor#, sensor# =
1
,
2
.
7.1.5 PCI-Probing – NVRAM Configuration Variables
The current state of the configuration variables are displayed using the
printenv
command, and are modified using either the
setenv
, or
the set-default command provided by OpenBoot.
The following NVRAM configuration variables are related to probing the
PCI buses:
pcia-probe-list
specifies the probe-list containing the device numbers to be probed at
the CompactPCI bus controlled by the on-board arbiter.
pcib-probe-list specifies the probe-list containing the device numbers to be probed on-
board.
pcia-io-probe-list
specifies the probe-list containing the device numbers to be
probed at the second CompactPCI bus controlled by the arbiter of the I/O
board. This variable is only effective if the I/O-523 is used as I/O-board
because only the I/O-523 provides an additional arbiter due to the support
of the second CompactPCI segment.
pcib-io-probe-list
specifies the probe-list containing the device numbers to be
probed on the I/O-board.