EtherScope™ Series II
Getting Started Guide
22
Removing and Installing the Battery
The battery is located behind the product stand.
To remove the battery, refer to the diagram in Figure 2
and do the following:
1.
Make sure that the instrument is turned off.
2.
Remove the yellow holster and pull the stand up.
3.
Push the release tab away from the battery.
4.
Pull up on the end of the battery that is close to the
release tab to disengage the connections. Then, lift
the battery out of the compartment.
To install the battery, insert it into the battery
compartment. Then, press on the battery near the release
tab until it locks into place. Finally, push the release tab
toward the battery to secure its position.
Operating the Instrument on AC Power
When the instrument is connected to AC power, you can
use the power supply as a continuous power source. In
this way, you can test for long periods of time without
depleting the battery.
To operate the instrument using AC power, refer to
Figure 2 and do the following:
1.
Connect the power cord to the external AC adapter
charger.
2.
Connect the AC adapter charger to the power jack on
the instrument’s side panel.
3.
Turn on the instrument.
