Fluke 9640A Series, Instruction Manual

Page: 180 / 324

9640A
Instruction Manual
4F-6
Table 4F-1. Emulated 8662A/8663 Commands (cont.)
Knob R1
R2
R3
X Used to select which digit is active for the knob
up/down command.
When under bus control, the 9640A has no concept of
cursor.
xxR4xx X Enables the knob setting when changing functions to
xx (eg frequency or amplitude)
R5 X Knob command that is not supported
RU/RD
RU/RD
X

Increment / Decrement the knob for digit edit
Single step in sweep mode
Learn Mode L1
L2 X
X A binary dump mode of instrument set up.
The 9640A does not support this feature.
AM AMnnPC

Sets up Amplitude Modulation
nn is the depth, PC is for percent
FM FMffKZ

Sets up Frequency Modulation
ff is the frequency, KZ is for units of kHz
PM PMddDG

Sets up Phase Modulation
dd is the angle, DG is for units of degrees
Pulse PL X Pulse Modulation
The 9640A does not have this functionality.
Modulation M0
M1
M2
M3
M4
MF






Turns Mod off
Internal 400 Hz
Internal 1 kHz
External AC
External DC
Set a modulation frequency
Sequence AS
SSrrrrrST
BLSSrrrrrST
X
X
X Recall of front panel storage registers in sequence.
The 9640 does not support this feature.
Status MS

X This is the error message response command.
See ‘Status Error Matching’ section.
Store/Recall ST
RC
X
X Save/recall.
The 9640A does not support this feature.
Sweep
Modes W1
W2
W3
W4




Sweep off
Auto Sweep
Manual Sweep
Single Sweep
Sweep
Marker X1 to X7 X Signal generated from the rear of the 8662.
The 9640A cannot generate this signal.
Sweep Step N1
N2
N3
N4
N5





Sets Sweep step size and log or lin sweep.