Fluke 9640A Series, Instruction Manual

Page: 148 / 324

9640A
Instruction Manual
4C-12
PM Subsystem
Keyword
Parameter
Form
*RST
Condition
Notes
[:SOURce]:PM
Command long form
This command node is only
available when the PM instrument
is selected.
[:SOUR]:PM:STATe[?] <bool> OFF
This selects whether the output
signal has an PM component
[:SOUR]:PM[:DEViation][?] <NRf>
0.0001
Rad
This selects the deviation in
Radians of the PM for the PM
instrument.
[:SOUR]:PM:DEViation:OFFSet[?] <NRf> 0.0 Rad
This value is added to the
deviation of the output value.
Changes to this value will be
reflected in the
PM:OFFSet:ERRor value
[:SOUR]:PM:DEViation:OFFS
:STATe[?]
<bool> OFF
This selects whether the offset
mode is present
[:SOUR]:PM:DEViation:OFFS
:APPLy[?]
<bool> OFF
This selects whether the offset
value is added to the output
deviation.
Note: The offset state must be on
for this command to operate
[:SOUR]:PM:DEViation:OFFS
:ERRor[?]
<NRf> 0.0 %
Adjusts the output depth by
setting the offset as an error
rather than an absolute.
[:SOUR]:PM:INTernal
:FREQuency[?]
<NRf> 1.0 kHz
This selects the modulation
frequency of the PM
[:SOUR]:PM:INT:FREQ
:OFFSet[?]
<NRf> 0.0 Hz
This value is added to the
modulation frequency of the
output value. Changes to this
value will be reflected in the
PM:INT:FREQ:OFFSet:ERRor
value
[:SOUR]:PM:INT:FREQ:OFFS
:STATe[?]
<bool> OFF
This selects whether the offset
mode is present
[:SOUR]:PM:INT:FREQ:OFFS
:APPLy[?]
<bool> OFF
This selects whether the offset
value is added to the output
modulation frequency.
Note: The offset state must be on
for this command to operate
[:SOUR]:PM:INT:FREQ:OFFS
:ERRor[?]
<NRf> 0.0 %
Adjusts the output depth by
setting the offset as an error
rather than an absolute.
[:SOUR]:PM:EXTernal
:TRIGger[?]
<name>
{DISable |
RISing |
FALLing}
DISable
Selects the type of external
trigger for PM