FLIR Detection
6. FLIR identiFINDER R300 Menu Reference
Settings and Commands
Bluetooth Device Name
The name of the device the FLIR identiFINDER R300 is currently paired with. Selecting this
item shows details about this device (Figure
162
, p.
148
).
Change Device
Guides you through the steps necessary to pair your FLIR identiFINDER R300 with a Blue-
tooth device.
Ô
To pair with a Bluetooth device
…
1. Prepare the Bluetooth device and make sure it can be found (perhaps called “discover-
able” or “visible” in the device’s settings).
2. Place the device in the vicinity of the FLIR identiFINDER R300 (up to ca. 10 m (33 ft)).
3. Initiate a search for devices with
Start Search
(Figure
156
, p.
145
).
Figure 156.
Ready to search for Bluetooth devices
4. Wait a few moments while the FLIR identiFINDER R300 searches for Bluetooth devices
supporting the required protocol (Figure
157
, p.
146
).
5. You can repeat the search if no device was found (Figure
158
, p.
146
) with
Search
.
6. Choose the desired Bluetooth device from the list shown (Figure
159
, p.
147
) with
Down
.
The device names are listed exactly as received from the detected devices. In case
of ambiguous names, you should change the name of the Bluetooth device to some-
thing unique (refer to the manuals of your Bluetooth devices on how to achieve
that).
If your desired device is not shown in the list, make sure its setup is correct, press
Exit
, select the command
Bluetooth Periphery
again and start another search.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015
145
