FLIR DNR516, Instruction Manual

Page: 18 / 198

DNR500 Series Rear Panel
5
1. Power input : Connect the included AC power cable.
2. On / Off switch : Turns the NVR on or off.
3. PoE Ports : Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN : Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
5. MIC IN/OUT : RCA input and output for 2–way audio.
Note
Audio-enabled IP cameras (not included) are required to use audio recording. You cannot record
audio from the input (e.g. microphone) connected to the MIC IN port.
6. HDMI : Connect to an HDMI monitor or TV (not included) to view the system interface.
7. USB port(s) : Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
8. eSATA : Connect a self-powered external eSATA HDD (not included) to extend the stor-
age capacity of the system or for data backup.
9. Alarm block : Connect alarm/sensor devices (not included).
10. VGA : Connect a VGA monitor (not included) to view the system interface.
11. VIDEO OUT : Video output (BNC) to connect the system to a secondary monitor.
12. RS232 : Service only; not supported.
#LX400023; r. 1.0/17332/17359; en-US
8