Festo PROFIBUD-DP, Elektronics Manual

Page: 73 / 154

2. Commissioning CPV−DI02 (PROFIBUS−DP)
2−15
Festo P.BE−CPV−DI02−EN en 0704NH
Basic configuration The CPV−DI02 valve terminal a lw a y s occupies 16 output
addresses. Carry out first a configuration of the basic device
as follows.
3. Pull the entry Base: 16DO" onto the 1st. line of the
configuration table
4
.
4. Pull the modules onto the next free line in the configur
ation table according to the extension of your CPV Direct.
Assign the starting address in the window Properties
DP slave"
5
.
No te
Pull the modules into the configuration table according
to the physical sequence of the extensions of your CPI
system.
Modifying the address The addresses are assigned automatically.
·
Double click on the relevant line in the configuration
table and modify the starting address of the
inputs/outputs in the window Properties DP slave".
No te
With S7−400 controllers, up to 4 bytes of addresses are
reserved for each DP identifier, depending on the version
status.
This concludes the station selection and configuration.