Festo Compact Performance CP-FB6-E, Manual

Page: 48 / 77

2.4 Configuration
2.4.1 Addressing the inputs/outputs
Further specifications on addressing and programming
can be found in the manuals for your controller and the
INTERBUS module.
PLEASE NOTE
A CP valve location occupies two addresses.
The following applies:
- lower-value address:
pilot solenoid 14
- higher-value address: pilot solenoid 12
The address assignment (process data assignment) of
the CP inputs/outputs and of the CP valve terminal on
the INTERBUS or compatible bus systems depends
principally on the INTERBUS module and your control-
ler.
CAUTION
There are different address assignments on the
INTERBUS. This is due to the assignment of the
processing data within the INTERBUS module and
not within the Festo CP system.
•
Make sure that DIL switch element 4 is set
correctly for your addressing (see chapter 1).
•
Observe the position of the high and low bytes
(byte n/n+1) when assigning the addresses for the
CP system, as the position of these bytes may be
swapped in the case of some control systems.
You thereby avoid errors in addressing the inputs/out-
puts.
2. Commissioning
CP FB6-E 9809c
2-19