Felder G 500, User Manual, Page: 28 / 84

28 28 29 29
���������������������������������������
�� ��
����������������������
����������
����������
�
�
���������������������������������������
�� ��
����������������������
����������
����������
�
����������
�
����������
�
�
����������
�
���������������������������������������
�� ��
����������������������
����������
����������
�
����������
�
����������
�
�
����������
�
Inspecting and setting
Edgebander
G 500
8.3.2 Set glue temperature
The electronic temperature adjuster must be positioned
on temperature which is suggested by manufacturer (in
factory normally adjusted at 200°C).
The quantity of glue to be spread can be adjusted.
When edging check the glue level in the pot and if ne-
cessary fill up as indicated in point a.
8.3.3 Exclusion of glue pot
The glue pot can be excluded by acting on the knob. At
the factory the glue pot is excluded to avoid any dam-
ages during transport. Always exclude the glue pot when
machine is travelling.
Fig. 14: Exclusion of glue pot
8.3.4 Maintenance: lubrication, adjustable torque control, substitution burnt glue,
substitution of burnt glue
Lubrication must be made only when machine is turned
on and the glue spreader is turning.
Use grease gun supplied with service box by inserting
it on the nozzle. Use lubricating grease for hot bearings
Arexons GC 300.
Lubrication must be done ecery 24-32 hours of working
with the machine.
Fig. 15: Greaser
Fig. 16: Nipple