Felder G 500, User Manual, Page: 26 / 84

26 26 27 27
Inspecting and setting
Edgebander
G 500
8 Inspecting and setting
8.1 Safety instructions
Warning! Danger – electric current: Work on electrical fittings may only be carried out by qualified person-
nel and in strict observance of the safety instructions.
Warning! Risk of injury: Improper adjustment and setup work can lead to serious bodily injury or mate-
rial damage. For this reason this work may only be carried out by authorised, trained personnel who are
familiar with the operation of the machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the ma-
chine, switch it off and secure it against accidentally
being switched on again.
• Before commencing any work with the machine, in-
spect it to ensure that it is complete and in technically
good condition.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Install the safety equipment according to the instruc-
tions and check that it functions properly.
8.2 Inspections
Warning! Risk of injury! Before putting the machine into operation, check that the safety mechanisms are
working well and that any moving parts are not blocked. Check that no parts are damaged, that they are
all well-assembled and are functioning correctly.
Damaged safety mechanisms and elements must be
repaired or replaced by a specialist or at a customer
service point authorised by the manufacturer.
Check that all safety precautions are activated and
thatthe safety mechanisms are in the right place. Ensure
that the EMERGENCY-OUT button is disengaged.
Fig. 12: Inspections
Check that the feed direction of the belt is in line with the
arrow.
A Belt feed
B Board entry
C Reference for the board clearance