37
!
Edgebander with glue pot
G 200 / G 220
Operation
9.2 Switching on the machine
Warning: Risk of injury due to insufficient preparation!
It is only permitted to switch on the machine if, for the work at hand, the required preconditions are fulfilled
and any preliminary work is completed. For this reason the instructions for adjusting, fitting and operating
(see the corresponding chapters) must be read before switching on the machine.
9.3 Switching off the machine
Attention! Never actuate the EMERGENCY STOP switch to switch off the machine as this will wear out the
brake shoes very quickly. The EMERGENCY STOP switch is only to be actuated in case of an emergency!
Only use the emergency stop switch in case of an emer-
gency!
If you want to switch the machine on again, you need to
disengage the EMERGENCY STOP switch: Pull the EMER-
GENCY STOP switch out and repeat the starting process.
9.4 Emergency stop
9.5 Working techniques
9.5.1 Authorised work techniques
9.5.2 Prohibited working techniques
The following working techniques are prohibited on this shaping unit:
• Use of single units
• Use for circular workpieces
• Working with pre-glued edging material.
• Insertion cuts - the workpiece is not worked over its entire length
All uses which differ from the following work techniques have not been intended for this machine and are therefore not
authorised.
• Applying coiled edge material (0.4 - 2 mm) onto right-angled edges
Summary of Contents for G 200
Page 47: ......
