39
Edgebander with glue pot
G 200 / G 220
Maintenance
10 Maintenance
10.1 Safety instructions
Warning! Risk of injury: Improper maintenance can cause serious injury or damage. For this reason this work
may only be carried out by authorised, trained personnel who are familiar with the operation of the machine
and in strict observance of all safety instructions.
• Before beginning any maintenance work on the machi-
ne, switch it off and secure it against accidentally being
turned on again.
• Ensure that there is sufficient space for working around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Following the maintenance work, re-install the guards
and check that they are functioning properly.
Warning! Danger – electric current: Work on electrical fittings may only be carried out by qualified personnel
and in strict observance of the safety instructions.
10.2 Maintenance work
All maintenance, upkeep and adjustment measures may only be performed with the main switch of the machine
turned off.
Failure to perform the prescribed maintenance will invalidate the warranty!
10.3 Maintenance schedule
10.3.1 Cleaning
Attention! Before you start to clean the machine, control if the machine parts have cooled down!
We recommend cleaning the machine of dust and chips
daily, especially the table-, roll- and guide surfaces.
The required cleaning and care products are available as
accessories.
Contact the manufacturer of the edging glue tapes for
information on the appropriate solvent to remove glue
residues.
Remove cutting residues from the machine regularly.
Read individual operation instructions:
Maintenance and preservation guidelines (in particular intervals)
Edgebanders - with belt feed drive
Summary of Contents for G 200
Page 47: ......
