30
" !
#
Edgebander with glue pot
G 200 / G 220
!
Glue pot
"
Knob
#
Hole
8.9 Glue pot
The glue pot unit has the function to heat the glue to up
to working temperature and to spread the hot melting
glue on the workpiece to be edged. For a correct
functioning of this unit, carefully follow these instructions:
1.
Fill up the glue pot to approximately 1 cm
underneath its edge with the hot melting granulated
glue.
Make sure that the type of glue used is compatible
with the conditions and the technical characteristics
of the machine.
2.
Adjust the electronic thermostat at the temperature
corrisponding to the one suggested by the
manufacturer (normally adjusted at 200° C at the
factory).
3.
The glue spreader starts turning automatically when
the temperature reaches 190° C. The quantity of
gluespread is adjustable by turning the knob; by
turning clockwise it increases, by turning unclockwise
it decreases. During edging control the amount of the
glue and refill if necessary.
4.
When lubricating, machine must be switched off.
Lubrication is done with the provided grease gun
pointing the nozzle in the hole. Use the lubricant for
high temperature bearings AREXONS GC 300. By
intensivley use maintanance machine every second
day.
5.
The visible screw positioned on the rear of the
machine fix the spring which pushes the glue pot.
Do not need any further adjustment.
Fig. 23: Glue pot
Attention! Risk of burning! Do not mix glue with wood chips or wood dust. Carefully take note of the hot
melting glue manufacturers advice.To avoid the deterioration of the glue always check the thermostat
adjustment and the quantity of the remaining glue. It is advisable to reduce the temperature of at least
50° C for the working breaks which last longer than 15 minutes. Since the good edge finishing depends
upon many factors, such as type of edge, type of workpiece, cutting quality, environment temperature etc. it
is therefore necessary to effect various tests to find the correct adjustment.
Making adjustments and preparations
Summary of Contents for G 200
Page 47: ......
