24
"
#
#
$
!
Edgebander with glue pot
G 200 / G 220
Proceed as follows to change the type of edge tape
(height, thickness and material).
Place the edge band onto the outrigger in such a way so
that it still turns easily.
The tape must be threaded between the two plates.
Use the knob to adjust the vertical position of the tape.
The knop can be moved in the 45° slot depending on
the width of the tape. Only tighten the knop so much
that it is still possible to move the tape manually (0,5 mm
clearance).
!
Outrigger
"
Tape
#
Plates
$
Handle grip
Making adjustments and preparations
8.1 Safety instructions
Warning! Risk of injury: Improper adjustment and working setup can lead to serious bodily injury or
material damage. For this reason this work may only be carried out by authorised, trained personnel who
are familiar with the operation of the machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the ma-
chine, switch it off and secure it against accidentally
being turned on again.
• Before commencing any work with the machine, in-
spect it to ensure that it is complete and in technically
good condition.
• Ensure that there is sufficient space for working
around the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Install the safety equipment according to the instruc-
tions and check that it functions properly.
Warning! Danger – electric current: Work on electrical fittings may only be carried out by qualified personnel
and in strict observance of the safety instructions.
8.Making adjustments and preparations
8.2 Edge tape positioning
Fig. 12: Edge tape positioning
Summary of Contents for G 200
Page 47: ......
