Felder G 200, Operating Manual

Page: 27 / 48

27 27
!
"
#
!
"
Edgebander with glue pot
G 200 / G 220
The feed system of the workpieces to be edged consists
of a belt drive with a special surface, so as to retain a
high friction and not to damage the workpiece.
It also has a good wearout strengh. The transversed po-
sitioned rolls give the workpiece the side shunted to glue
the workpiece together.
The feed speed is 5 m/min, to get a good quality work-
piece. The motor which has 3 phases is well dimensi-
oned.
!
Break switch
"
cylinder
#
Valve
!
Handwheel
"
Display
Making adjustments and preparations
Fig. 17: Pneumatic shears with trail
8.7 Pneumatic shears with trail
This unit is relevant to dislodge the protrusion of the tape
(at the outset and the end).
As soon as the workpiece passes the valve, the shear
cuts of the protrusion at the beginning. The shear stays
closed till the workpiece has passed valve. The scissors
opens and cylinder moves the whole unit with the workpi-
ece. The unit reaches the workpiece at the valve and cuts
the protrusion at the end. The scissor unit stays closed
and on place until the valve is pushed.
The shere opens and is waiting for the next workpiece.
8.8 Automatic workpiece-feed
Fig. 18: Automatic workpiece-feed