Felder G 200, Operating Manual

Page: 22 / 48

22
!
"
Edgebander with glue pot
G 200 / G 220
The pneumatic control unit is mounted under the machine
rack and is reachable by the security door.
The control unit is adjusted factory made. A sample work-
piece was made to do the engagement for the machine.
It is supplied with the machine.
If you are dissatisfied with your deliverable then you can
justify the control unit as follows:
How to justify trail speed of the cutting unit
This adjustment is very delicate and it is advisable not to
misplace the screw.
Before making any changes, check that the pressure of
the compressed air system is not less then 6 bar. Also
check the cleanness of the workpiece guides.
If you have to misplace the screw E nevertheless, mark
the position of the screw with a felt pen, that you can get
back to the old position.
!
Door
"
Screw
Setup and installation
7.3 Dust extraction
7.4 Pneumatic control
Fig. 10: Pneumatic control
Warning! Risk of injury! The dust extraction hose must be non-flammable and must not conduct electricity! For
this reason, only use genuine FELDER dust extraction hoses!
• In addition, the vacuum performance must be sufficient
to achieve the required negative pressures and an air
speed of 20 m/s at the connector. (see “Technical
data”)
• Check the air speed before putting the machine into
operation for the first time and after essential changes.
• The dust extractor setup must be controlled before the
machine is put into operation for the first time. Check for
obvious defects on a daily basis and the efficiency on a
monthly basis.
• The dust extractor must be connected to the machine
in such a manner that it runs in unison with the
machine.
• The dust extraction hoses must be electrically conduc-
tive and grounded to prevent electrostatic
build up.
• Use dust extractors with reduced dust emission to clean
dust from the machine.
Note: As a rule, all units must be vacuumed during use. A time delayed socket is available as an accessory.