25
!
"
!
#
"
$
Edgebander with glue pot
G 200 / G 220
!
Handle grip
"
Pressure roller
#
Feed stop
$
Tape feeder roller
!
Break switch
"
Screws
Making adjustments and preparations
Fig. 13: Edge tape feeding
Fig. 14: Infeed fence
The function of this unit is to bring the edge tape and the
workpiece together (up to the first pressure roller.
To clamp a new edge tape you can pivot the roll by
using knob.
Thread the tape up to the point so as to be able to press
the roller again onto the knob.
The edge tape is fed through as a result of the workpiece
moving over the roller, which through a gearbox, causes
the tape feeder roller to move.
This step used to cut edge tape from the coil.
The cutting unit works pneumatically. It is controlled by
the micro switch O01 and is tripped by the overrunning
workpiece.
The protrusion of the glued on edge tape is justified
factory-made.
If you need to change this protrusion you have to open
the two screws.
Now you can displace the micro switch O01 into the
direction of ingress (reduces the protrusion) into the
direction of discharge (increases the protrusion).
8.3 Edge tape feeding
8.4 Tailor edge band from coil
Summary of Contents for G 200
Page 47: ......
