34
max 2 mm
max 2 mm
min. 90 mm
!
$
%
%
&
"
#
Edgebander with glue pot
G 200 / G 220
!
Pad feelers
"
Handle 1
#
Handle 2
$
Sticker
%
Screws
&
Edge protrusion
Making adjustments and preparations
8.11.1 Flush trimming unit
Fig. 26: Flush trimming unit
This unit is used to trim the edge protrusion on both
workpiece sides. It depends on the trimming unit and
workpiece thickness to do a sharp, beveled or a round-
ed edge.
The unit is equipped with 2 counter rotating cutters
(70 mm diameter) with 4 WIDIA-knives with a tilted cut
of approximate 15°. As a special accessory you can use
other trimmers too. Rotational speed about 9000 rpm.
The two shapers have a floating mounting and copy the
worpiece shape with the 2 pad feelers.
If you change the thickness of the workpiece, the height
of the shaper above justifies automatically. Both flush
shapers are equipped with suction pipes Ø 60 mm.
It is absolutely necessary to work with an efficient dust
extraction system.
The choice of your shaper tools depend on following
parameters:
• admissible diameter: 70 mm
• spindle diameter: 12 mm
• max. width shaper: 20 mm
• max. weight per shaper: 250 g
• max. RPM: 15.000
The axial regulation can be done by actuating the two
knobs. Thereby the size of the bevel misplaces. This
adjustment will have to be carried our frequently. Justify
the tool when it is spinning and pay attention to the
sticker (on the machine back).
The vertical fent is done by the screws. The screws adjust
the height of the pad to match the trimmer.
Attention! Spin the screws with the same number of turns that the copy pad feelers stay parallel to the working
table. You can shape maximum 2 mm of edge protrusion on both sides A2.
8.11 Flush trimming unit
Summary of Contents for G 200
Page 47: ......