40
"
"
!
Edgebander with glue pot
G 200 / G 220
!
Socket head cap screws
"
Fixing screws
Maintenance
10.3.2 Lubrication
Generally there is no lubrication necessary, because the
ball bearings are free of maintenance and the sliding
10.3.3 Exchanging tools
Fig. 29: Exchanging tools
Fig. 30: Exchanging tools
Exchanging tools of edge tape cutting unit:
1.
Open belt feeding unit and take off security plate by
loosening the socket wrenches. Now you can reach the
knives of the end trimming unit.
2.
Exchange the knives by loosen the screws.
3.
At the installation go ahead in reversed order. Tighten
the screws and check that the knives hold tight.
4.
Mount the security plate again.
5.
Proceed in a similar fashion for the front cutting unit.
Grinding the knives:
1.
Remove the knives to be grinded (as described above).
2.
Mark the knife so it can be assembled in the same
position again.
3.
Grind the knives only on the bevel side. Repeat the
process for the other knife.
bushes and linear guiding are self-lubricating.
Summary of Contents for G 200
Page 47: ......
