FEC Handheld Nutrunner HFC3000, Instruction Manual

Page: 175 / 231

Chapter 8 Options
PAGE 8-7
8-1-6 Checking the Capacity of the CF Card
When the remaining capacity of the memory card falls to no more than 1%, the CF ACCESS LED
lights (orange). The storage capacity of the memory card can be checked from the controller
display.
● Procedures for Confirming the Storage Capacity of the Memory Card
1. The controller must be in a state (Bypass) where it cannot be started by external control will not be
running. (The READY signal should be
is “ON.”)
2. Use the “◄” and “►” buttons on the controller display until the System Setting Mode is indicated as
[SYS].
3. Use the
“
▲
” and “
▼
” buttons on the controller until “400” is indicated at the COUNT/D-No. Display.
4. The value indicated at the upper stage of the display is the storable capacity (units: MB) of the CF
memory card. (For firmware version 1.209 or earlier: (Units: %))
・
When the CF ACCESS LED lights RED, storage into the memory card is
discontinued to prevent mismatch of the stored contents of the fastening
results and the fastening curves.
CF ACCESS
(Controller firmware version V1.209 or later)
Orange: Storage capacity is no more than 200MB
Red: Storage capacity is no more than 20MB
(Controller firmware version V1.209 or earlier)
Orange: Storage capacity is 1% or less
Red: Storage capacity is 0.1% or less
Caution